Aritech ATS4000 Servisní příručka stáhnout pdf (Strana 66)

66 ATS Designers Guide

Table 4-12 Mapping zones and outputs in the elevator controller.

Elevator – local

address

First input First zone

Elevator 1 1 1

Elevator 2 65 65

Elevator 3 129 129

Elevator 4 193 193

4.5 Cards and Readers

4.5.1 Advisor MASTER System Readers

The list of ATS system devices that can serve as user interface for access control is

contained in Table 1-10. These are keyboards, readers, keyboards with integrated

readers and the interface to connect other readers. Each of these devices can be used

for user verification in access control and a significant simplification is the ability to

connect them directly to the system or local bus. This decreases the complexity of the

wiring and reduces the installation time. The smart cards and readers offered with the

ATS system deserve special attention. They have been described in detail in chapter

6. ATS system Smart Cards.

4.5.2 Other readers

Often the system design guidelines contain specific requirements as to the type of access

control cards and readers. The ATS systems can use any reader compatible with the

Wiegand hardware interface, and any card or token that sends a data stream of up to 48

bits. The details of using cards of different formats are described in paragraph 0. To

connect a Wiegand interface reader to the ATS system the ATS1170 interface, or any of

the reader outputs of the ATS1250/60 need to be used – it has to be kept in mind, that

the maximum distance from the reader to the interface cannot exceed 70m, see section

3.2 which describes the wiring. The method of connecting the devices to the control panel

– the system bus – or access control DGP – local bus and ATS125 reader inputs – has

been detailed in the following paragraphs.

4.5.2.1 HID

HID readers use the Wiegand interface. They can be used in the Advisor Master system

by connecting them to the system, to the direct reader inputs of the access control DGP,

or through the ATS1170 to the system bus, as well as the access control DGP local bus –

see Drawing 4-6. This method can be used to connect any Wiegand interface reader..

Control panel

TS1170

HID

ATS1250/60

HID

TS1170

HID

TS1170

HID

System bus

Local bus

Drawing 4-6 Connecting the Wiegand interface readers to the ATS system.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 82 83

Komentáře k této Příručce

Žádné komentáře

Aritech ATS4000 Servisní příručka Strana 66

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Aritech ATS4000