
14 ATS Designers Guide
The ATS1155 keyboard is a solution for areas with high risk of vandalism. The metal,
damage resistant keyboard and the electronics part of the device are mounted
separately. Additional system state diodes can be mounted separately as well. The set
consists of the keyboard, a PCB board and connection cables.
The address and bus termination are set using a DIP switch.
1.2.1.5 ATS1151/56
3 system state diodes
1 area state diode*
Inbuilt magnetic card reader (ACT600 cards)
Opening and pry-off tamper alarm
Metal cover
Suitable for outdoor use
Dimensions (LxHxD mm) ATS1151: 96x67x28
Dimensions (LxHxD mm) ATS1156: 96x96x40
*- the red state diode serves to display the RAS station area state as well.
The cover design has been proven in the ACC series access control systems from
Aritech. The design, as well as a heater integration option, enables the unit to be installed
outdoors even in low temperatures.
1.2.1.6 ATS1190/92
2 system state diodes (programmable)
Reader configurable via a proximity card, or internal
programming menu.
Optical pry-off tamper alarm
Suitable for outdoor use
Vandal-proof design
RS485 or Wiegand interface, automatically detected
Dimensions (LxHxD mm) ATS1190: 36x110x20
Dimensions (LxHxD mm) ATS1192: 42x150x16
Due to its characteristics and price, the ATS1190/92 is a very attractive solution for small
to medium systems. A synthetic, water-proof resin that fills the housing makes the unit
resistant to damage, as well as severe weather conditions.
Compatible with:
ATS147x cards
ATS1621 programmer
Additional accessories for the ATS1190 Reader are replaceable covers in white, red,
grey, beige and black.
1.2.1.7 ATS1170
2 reader state diodes
Tamper input
Wiegand or Clock-Data reader interface
Door lock relay output
Supports autonomous mode for 20 cards
Dimensions: B+
Wiegand type card reader interface used to connect readers from other manufacturers
and systems to the ATS system. This unit supports autonomous mode, independent of
Komentáře k této Příručce