Aritech ATS4000 Servisní příručka stáhnout pdf (Strana 19)

ATS Designers Guide 19

1.3.1.5 ATS1290 addressable devices DGP.

32 Point ID

addressable devices

32 system outputs

PID bus learning mode

Power supply: 12V DC

This new device in the Advisor MASTER system allows the use of the local

communications bus interface of the DGP module to connect sensors to the alarm

system. To communicate with the devices, an open architecture Point ID

interface is

used. The bus planning details, recommended wiring etc. can be found in section 3.2.2.

In addition to the DGP module a whole range of, Point ID compatible, devices is

available, and listed in the table below.

The device can be programmed via the remote device menu. The DIP switches serve

only to supply the DGP module address, and to activate the bus terminator.

The use of addressable sensor technology significantly reduces the cost of system wiring

by simplifying it, reducing the installation time, the amount of materials used etc.

Table 1-18 List of available Point ID devices

Product Description Inputs Outputs

SI-AD Universal, single input Point ID module 1 0

AD011 Universal Point ID module, 1I/1OC 1 1

AD044

Universal Point ID module, 4I/4O, monitored,

externally powered, relay outputs

4(+4) 4

AD111

Point ID module, 1I/1OC installable inside the

sensor.

1 1

AP750-AD PIR sensor, range: 15,2m; 7 curtains; 1 1

EV435-AD PIR sensor, 9/16m, 9 curtains, Point ID interface 1 1

EV435AM-AD

PIR sensor, 9/15m, 7 curtains, antimasking,

Point ID interface

2 2

1.3.1.6 ATS1250 4 door Access Control DGP

4 bi-directional passages

4 direct Wiegand reader inputs

16 remote readers on the local bus

16 onboard alarm zones

4 door lock control relay outputs

up to 48 additional outputs

Advanced access control functions

48 macrodefinitions

Full local copy of the user database

Autonomous operation mode

Integrated 4,5A switching mode power supply

Auxiliary battery back-up

L type housing

Dimensions: D

A 4 door controller provides advanced access control functions for the users of the

Advisor MASTER system. The device has been designed to work independently of the

control panel unit. The autonomy of the controller is assured by a full local copy of all the

system settings, including both user and card databases. Additionally the equipment has

been designed to directly control locks, entry buttons (RTE), readers, door and lock alarm

zones, tamper alarms etc. This ensures, that even when communication problems with

the control panel occur, the controlled passages will function flawlessly. Communications

with the control panel is not necessary for proper functioning of the passages, although

the available DGP mainboard inputs, dedicated to access control tasks, can be

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 82 83

Komentáře k této Příručce

Žádné komentáře

Aritech ATS4000 Servisní příručka Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Aritech ATS4000