Aritech ATS4000 Servisní příručka stáhnout pdf (Strana 12)

12 ATS Designers Guide

Table 1-10 RAS device list (System Bus devices)

User interface Product Description

Alarm AC Prog.

ATS1100 Keypad, 2*16 characters LCD/8 zone LEDs x x x

ATS1105

Keypad, 2*16 characters LCD /8 zone LEDs with

Wiegand reader interface.

x x x

ATS1110 Keypad, 2*16 characters LCD/16 zone LEDs x x x

ATS1111 Keypad, 4*16 characters LCD/16 zone LEDs x x x

ATS1115

Keypad, 2*16 characters LCD/16 zone LEDs with

inbuilt ATS card reader.

x x x

ATS1116

Keypad, 2*16 characters LCD/16 zone LEDs with

inbuilt ATS card reader.

x x x

ATS1155

Outdoor, vandal-proof keypad (metal), 3 diodes,

detached electronics

x x

ATS1151 LED keypad (3 diodes) in metal housing, no LCD x x

ATS1156

LED Manipulator (3 diodes) in metal housing with

ATC600 magnetic card reader (no LCD)

x x

ATS1190 Proximity reader (does not require an interface) x x

ATS1192

High resistance proximity reader (does not require an

interface) indoor/outdoor

x x

ATS1170

Wiegand reader interface (single door controller) –

PCB B+

x x

1.2.1.1 ATS1100/05

LCD 2x16 characters

8 area state display diodes

3 system state diodes

4 programmable function keys

Opening and pry-off tamper alarm

ATS1105 contains a Wiegand equipment interface.

Dimensions (LxHxD, mm): 168x126x40

The ATS1100/05 unit is one of the most basic RAS stations of the ATS system, granting

access to all control, management and programming functions of the system. The limited

amount of diodes does not allow display of the status of all areas at once on a single

device. By choosing (using a DIP switch) the area range for display, the manipulator can

be configured to display zones 1-8 and 9-16. Like all RAS devices the ATS1100/05 has

an input port for the exit button, and an output port for door lock control from the control

panel. Additionally, the ATS1105 is equipped with a Wiegand reader interface. It enables

the connection of such a reader without installing an additional Wiegand interface –

ATS1170.

The device address as well as bus termination, and other functions for example:

keyboard and display backlight, can be set using DIP switches. The connector clamps

and the DIP switches can be found after removing the unit’s cover.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 82 83

Komentáře k této Příručce

Žádné komentáře

Aritech ATS4000 Servisní příručka Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Aritech ATS4000