Aritech ATS3000 Uživatelská příručka stáhnout pdf (Strana 21)

ATS2000/3000/4000/4500 Manager’s Guide

4. The display shows:

Fix the problem (e.g. close the door).

 Re-alarming: If your system has been programmed to remind you about alarms, it

will automatically re-alarm after a preset time unless the cause has been fixed, no

matter how many times you acknowledge the alarm.

When a re-alarm does occur, the letter preceding the zone number will not be

shown.

Resetting a zone in alarm

• The LED of the area in alarm flashes red on the keypad.

• The sirens are active (if programmed),

• When an alarm occurs, the display There Are No Alarms In This Area disappears

from the top line. Instead you see:

 Zones in Tamper Alarm are displayed with a T in front of the zone number.

To reset a zone in alarm

1. Enter your PIN code.

2. Press [OFF].

The display shows.

3. Enter the area number of the zone in alarm (flashing LED) and press [ENTER].

The display shows:

4. Determine where the alarm occurred by reviewing the quick alarm history (page 21).

5. Fix the problem.

Further information about alarms

• If the alarm conditions are no longer valid, and the alarm has been reset, you must

contact your central station company to ensure that they take no further action.

There are no alarms in this area

Code:

There Are No Alarms In This Area

Code:

0- All 1, Area One 2,

rea Two 3, Area three

Enter Area:

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

Žádné komentáře

Aritech ATS3000 Uživatelská příručka Strana 21