Aritech ATS3000 Uživatelská příručka stáhnout pdf (Strana 20)

ATS2000/3000/4000/4500 Manager’s Guide

WHAT TO DO WHEN THERE IS AN ALARM

When there is an alarm, the LED of the area in alarm flashes red on the keypad. The

message “There are no alarms in this area” is no longer displayed. If it is a local alarm,

this is shown.

An area can have several zones associated with it. When there is an alarm, it is important

that you know exactly which zone is causing the problem so that you can quickly deal

with it.

Resetting a local alarm

• The keypad emits a discontinuous tone until the local alarm is acknowledged (if

programmed).

• The LED of the area in alarm flashes red on the keypad, depending on how it has

been programmed.

• The display shows the following:

To reset a local alarm

1. Press [ENTER] twice.

2. The zones causing the alarm are listed either:

One at a time

e.g.

As a list of numbers

e.g.

You now know which zones are causing the problem.

3. From either display:

Option Action Result

Acknowledge the

local alarm

Press 0 and

[ENTER]

Acknowledge the local alarm (see

below). Depending on programming a

user code is required to reset.

Display the zone

name in full

Press [NEXT] Display the complete zone name.

Update the list of

zones

Enter the zone

number and press

[ENTER]

Update the list of zones and display the

next zones in the list (if any).

Local Alarm

Code:

Local Alarm On A4. Rear Fire Doo

NEXT or ENTER

Local Alarm On A4, A5, A9, NEXT

Zone No:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 70 71

Komentáře k této Příručce

Žádné komentáře

Aritech ATS3000 Uživatelská příručka Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Aritech ATS3000