Aritech CS175 Instalační příručka stáhnout pdf (Strana 97)

CS175-275-575-875 Installation Guide 97

Repeater

Press and then release the tamper switch.

16.4.4 Deleting transmitters

The following steps describe how to delete transmitters from the module.

The module ignores a transmitter but does not remove its identification from the module’s

memory. The transmitter can be reactivated later or a new one can be learned into the

zone.

Steps

1. Press 8 to enter programming mode.

2. Enter a Go to Program Code. The keypad prompts you to enter a module number.

3. Enter the module number and press #. The module number is iis the DIP switch

setting, for example 35,36,38 or 39.

4. Press XX# where XX is the zone number (1 to 168) and where # is the entry key.

5. Press 1 to change the transmitter feature 1 (Transmitter Enabled). The first bit in

the segment changes from ‘1’ to ‘-, to indicate that the wireless component is

disabled.

6. Repeat steps 4 to 5 until all transmitters are deleted.

7. Press the Exit key twice to exit programming mode.

16.4.5 Testing wireless transmitters

Use the walktest to test the wireless transmitters.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 166 167

Žádné komentáře

Aritech CS175 Instalační příručka Strana 97